i would imagine being i placed all three USB options above the DVD drive and Hard Drive it 'should' attempt to boot from those before Windows 10 loads up, correct?Īlso, the Laptop has three USB ports but i assume it does not matter which one i use? (with the F5 and F6 keys i can adjust the order of those options above) So basically when i enter the 'Boot Order' screen, which i assume is where i want to be(?), it shows. Internal Network Adapter boot = Disabled or Enabled (only two you can choose) of which you can adjust from 0/5/10/15/20 seconds options, below this in the same menu.ĬD-ROM Boot = Enabled or Disabled (only two you can choose)įloppy Boot = Enabled or Disabled (only two you can choose) once i enter there it shows.į10 and F12 Delay (sec). ESC to exit.' so basically i ultimately enter the F10 to get to the general BIOS settings but inside there is very little you can configure and ultimately boils down to System Configuration > Boot Options. Then below that shows 'Press F10 to BIOS Setup Options. I assume only F9 and F10 is of any concern with what i am trying to do. you can change boot order but this seems to do nothing.īut once you load up the initial BIOS screen it shows. It appears there is three types of USB stuff you can try to boot from but it simply does not work and there is very little you can configure in the BIOS menu. main BIOS menu shows "InsydeH20 Setup Utility Rev. but after i upgraded i loaded the system defaults and rebooted to make sure no funny glitches remained. Laptop model = HP Pavilion dv5-1002nr (NOTE: i upgraded the laptops firmware which added one additional boot option which appears to be external USB DVD drive. it's basically a USB card reader with a SD card in it that connects to a computer with the usual USB port. I can't seem to get a Laptop to boot from USB even though that same thing works on my main computer no problem.